The 3Com Telephone Local Configuration Application - 3Com 3C10402B Administrator's Manual

The 3Com
Telephone Local
Configuration
Application

The 3Com Telephone Local Configuration Application

Table 79 LUI Menu Items (continued)
Menu Option Description
AB1 Set NCP Note: See menu option 6 Advanced Settings for information
MAC about how to access this option on 3101B and 3102B Business
Telephones.
NOTE: This
setting is for test Lets you specify the MAC address of the Call Processor. In all but
networks only. special circumstances, the system messages communicate this
information and you do not need to manually configure the
MAC address.
To change a telephone back to its default setting, enter all Fs for
the Call Processor MAC address.
AB2 Show Note: See menu option 6 Advanced Settings for information
EEProm about how to access this option on 3101B and 3102B Business
Telephones.
Lets you scroll through the locations in the memory of the
telephone. The information is presented in hexadecimal format
and can be properly interpreted only by a 3Com service person.
AB3 Ping H3/IP Note: See menu option 6 Advanced Settings for information
about how to access this option on 3101B and 3102B Business
Telephones.
Runs an H3 IP ping test. See
information.
AB4 Reset Phone Note: See menu option 6 Advanced Settings for information
about how to access this option on 3101B and 3102B Business
Telephones.
Resets the device. You can perform the same task by removing
power from the telephone. However, Option AB4 can be useful
for cordless phones, which cannot easily be disconnected from
power.
You can manually configure most 3Com telephones using the telephone
Local User Interface (LUI) utility to define the settings the device needs to
communicate with the Call Processor. For the 3100 Entry Telephone,
which does not have a display panel to show configuration information,
use the 3Com Telephone Local Configuration application (TLC).
The TLC application enables you to specify the information that a device
requires to communicate with the Call Processor over a routed network
without using DHCP. You must still use the Auto Discover feature or
manual configuration through the NBX NetSet utility to add the device to
the system database.
Using H3PingIP for more
429