3Com 3C10402B Administrator's Manual page 325

Sample Solutions Using Dial Plan Configuration File Commands 325
DestinationRouteOperation Create 1 1 1 stripLead 1
DestinationRouteOperation Create 2 1 1 stripLead 1
Explanation: Creates, in route 1, entry 1, operation number 1. This is a
stripLead operation, which removes the first digit from the dialed string,
then and passes the remaining digits to the carrier.
Customer Requirement 5. Assume that you want to transmit CLIP
information about outgoing calls. You use internal telephone extension
numbers from 3000 to 3099. There is no DDI/DID, so the T1 or E1 line has
only a single number (555-555-1212). All incoming calls are routed by
default to the Auto Attendant.
Add these lines to the dial plan configuration file:
PreTranslator Create 1 CLIP Internal Ext to Single Number
Explanation: Create pretranslator table 1 called "CLIP Internal Ext to
Single Number."
PreTranslatorEntry Create 1 1 3
Explanation: For pretranslator 1, create entry 1, which applies when the
first digit in the sequence is 3. (All internal telephone extensions begin
with the number 3.)
PreTranslatorOperation Create 1 1 1 replace 555 555 1212
Explanation: For pretranslator 1, entry 1, create operation 1, which
replaces the extension number with the string 555 555 1212.
Customer Requirement 6. Assume that you want to use two different
long distance carriers at different times of the day, to obtain a cost saving.
To select one long distance carrier from 7:30 a.m.) to 3:00 p.m., prepend
1010321 to each call. To select another carrier and obtain a lower rate
from 3:00 p.m. until opening business hours the next day, prepend
1010220. This assumes the business is not open on weekends.
Add these lines to the dial plan configuration file:
TableEntry Create 1 99 91 12 12 LongDistance 0 27
Explanation: In Table 1 (Internal table) entry 99, creates an entry which
looks for the digits 91 at the beginning of any 12-digit sequence (since
both Min and Max are set to 12). If the system detects such a sequence, it
assigns LongDistance as the class of service.
Because system software does not use the priority value, the system
leaves 0 (zero) as the value, and assigns the call to route 27.