Dial Plan Configurations And Vpim - 3Com 3C10402B Administrator's Manual

302 C 11: D
HAPTER IAL
Table Create 1 Internal 4 Digit Extensions
/
/
TableEntry Create
/
/
DestinationRouteOperation Create
Dial Plan
Configurations and
VPIM
P
LAN
Figure 18 Dial Plan Entries for International Long Distance
ID Entry Digits Min Max
-- ----- ------ --- ---
1
With Voice Profile for Internet Mail (VPIM), telephone users on one
system can send voice mail to a user on another VPIM-compliant system.
For detailed information about VPIM and how to configure VPIM settings,
see "Voice Profile for Internet Mail" on page 223
To send a voice mail message to a user on another VPIM-compliant
system, a telephone user first composes the voice mail message, using
the commands in the user's voice mailbox. Depending on how you
configure the system's dial plan, the telephone user can specify the
destination in two ways:
If the dial plan is configured for site codes, the telephone user
■
specifies the destination site code followed by the extension of the
person for whom the voice mail message is intended.
If the dial plan is configured without site codes, the telephone user
■
specifies the extension of the person for whom the message is
intended. This requires that each site use a unique extension range for
telephones.
A telephone user who knows the IP address of a VPIM-compliant voice
mail system and the extension of a person who uses that system can
compose a voice mail message and then send it using these steps:
1 Dial the IP address, pressing the * key after each field in the address,
including the last field.
2 Dial the extension of the person followed by # key.
You must decide whether to use site codes or unique extension ranges
when you configure the dial plan.
3 9011 12 64
Route Entry OperID Operation Value
----- ----- ------ --------- -----
3
Class Prio Route
------------ ---- -----
International
2 1 stripLead
0 1
4