3Com 3C10402B Administrator's Manual page 251

already been created. For more information see
Conferencing Module Configuration"
To configure the settings of the Conference Attendant for restricted
conferences:
1 Log in to the NBX NetSet utility using the administrator login ID and
password.
2 Click SIP Applications > 3Com IP Conferencing Module, and then click the
Conference Attendant Settings tab.
3 Type the extension that the system uses for IP Conferencing. This
extension must be an unused extension on the system in the range of
external extensions, 6000-7999 in a 4-digit dial plan. You must use a
different extension from the one you used to configure the IP Conference
Server settings.
4 Type a description for the IP Conferencing Module.
5 Type the IP address for the IP Conferencing Module.
6 Type a port number. A SIP endpoint is identified by the IP and port
combination.
Port 5092 is the port number defined in the IP Conferencing server for
running the Conference Attendant.
7 Type the maximum number of simultaneous sessions. Each session
requires one system device license. See
on page 237 for more information.
8 Click OK or Apply to save your changes.
When you click Apply, the system adds a trusted endpoint. Click SIP
Applications > Trusted SIP Interfaces to verify.
9 Configure the dial plan. You must add an extension list to the dial plan to
support routing of extensions to the conference server or edit the
extension list if one has already been created. For more information see
"Dial Plan and 3Com IP Conferencing Module Configuration"
page 252.
Enabling and Configuring SIP Mode
"Dial Plan and 3Com IP
on page 252.
"Licensing and Resource Limits"
251
on