170
C
8: PSTN G
HAPTER
Digital Line Card
Status Lights
C
ATEWAY
ONFIGURATION
PSTN Gateway Configuration > ISDN BRI Groups
■
2 Click the name of a group.
3 Click the Membership tab.
4 Verify that all channels are present.
Completing the Configuration
To complete the Digital Line Card installation:
1 Click the appropriate link:
PSTN Gateway Configuration > T1 Channels
■
PSTN Gateway Configuration > ISDN PRI Channels
■
PSTN Gateway Configuration > ISDN BRI Channels
■
2 Wait approximately 30 seconds for the status of each channel to change
from Ready to Idle.
3 Verify the status of each channel.
If the channel status does not display as Idle, verify that you have enabled
the On Line check box for the card, the span, and the group.
While you are waiting, you can click Apply to refresh the list of channels
and to see the updated status. If you have connected the telephone
company's line to the Digital Line Card, the Nominal (on 3C10165C E1
and 3C10116C T1 Digital Line Cards) or the CO (on 3C10165D E1 and
3C10116D T1 Digital Line Cards) status light on the front panel of the
Digital Line Card illuminates (solid green). If the light does not illuminate
and you have an E1 or T1 line connected, disconnect the line and connect
a loopback connector. If the light now illuminates, contact the telephone
company for assistance with the line. If the light does not illuminate,
contact your 3Com Technical Support representative.
This section describes:
BRI-ST Card Status Lights
■
E1 and T1 Digital Line Card Status Lights
■
BRI-ST Card Status Lights
Each of the four spans on a BRI-ST card has status lights that indicate the
status of the span
(Table
36).