Telnet Commands; Telnet; Transport Input Telnet; Section 3.4 "Telnet Commands - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

3.4 Telnet Commands

This section describes the commands you use to configure and view telnet settings. You
can use telnet to manage the device from a remote management host.

3.4.1 telnet

This command establishes a new outbound telnet connection to a remote host. The host
value must be a valid IP address. Valid values for port should be a valid decimal integer in
the range of 0 to 65535, where the default value is 23. If [debug] is used, the current telnet
options enabled is displayed. The optional line parameter sets the outbound telnet
operational mode as 'linemode', where by default, the operational mode is 'character
mode'. The noecho option disables local echo.
Format
Modes

3.4.2 transport input telnet

This command regulates new telnet sessions. If sessions are enabled, new telnet sessions
can be established until there are no more sessions available. If sessions are disabled, no
new telnet sessions are established. An established session remains active until the session
is ended or an abnormal network error ends the session.
Default
Format
Mode
3.4.2.1 no transport input telnet
This command disables telnet sessions. If sessions are disabled, no new telnet sessions are
established.
Format
Mode
Administrative Access Commands
telnet <host> <port> [debug] [line] [noecho]
Privileged EXEC
User EXEC
enabled
transport input telnet
Line Config
no transport input telnet
Line Config
v1.0, October 2008
3-9