Show Classofservice Dot1P-Mapping - NETGEAR ProSafe GSM7224P User Manual

The last precedence applies to all non-TCP traffic. For example, in a 3-color system, four of
each parameter specified: green TCP, yellow TCP, red TCP, and non-TCP, respectively.
Format
random-detect queue-parms queue-id-1 [queue-id-2 ... queue-id-n]
minthresh thresh-prec-1 ... thresh-prec-n max-thresh thresh-prec-1 ...
threshprec-n drop-probability prob-prec-1 ... prob-prec-n
Modes
• Global Config
• Interface Config
no random-detect queue-parms
Use this command to set the WRED configuration back to the default.
Format
no random-detect queue-parms queue-id-1 [queue-id-2 ... queue-id-n]
Modes
• Global Config
• Interface Config
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a
whole. Also known as rate shaping, traffic shaping has the effect of smoothing temporary
traffic bursts over time so that the transmitted traffic rate is bounded.
Format
traffic-shape <bw>
Modes
• Global Config
• Interface Config
no traffic-shape
This command restores the interface shaping rate to the default value.
Format
no traffic-shape
Modes
• Global Config
• Interface Config

show classofservice dot1p-mapping

This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes
for a specific interface. The <unit/slot/port> parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the
802.1p mapping table of the interface is displayed. If omitted, the most recent global
configuration settings are displayed. For more information, see
.
page 79
Format
show classofservice dot1p-mapping [<unit/slot/port>]
Mode
Privileged EXEC
ProSafe Managed Switch
Quality of Service (QoS) Commands
445
Voice VLAN Commands on