Area Default-Cost (Ospf); Area Nssa (Ospf) - NETGEAR ProSafe GSM7224P User Manual

no ip ospf area
Use this command to disable OSPF on an interface.
Format
no ip ospf area [secondaries none]
Mode
Interface Config
1583compatibility
This command enables OSPF 1583 compatibility.
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in
the routing domain are capable of operating according to RFC 2328,
OSPF 1583 compatibility mode should be disabled.
Default
enabled
Format
1583compatibility
Mode
Router OSPF Config
no 1583compatibility
This command disables OSPF 1583 compatibility.
Format
no 1583compatibility
Mode
Router OSPF Config

area default-cost (OSPF)

This command configures the default cost for the stub area. You must specify the area ID and
an integer value between 1-16777215.
Format
area <areaid> default-cost <1-16777215>
Mode
Router OSPF Config

area nssa (OSPF)

This command configures the specified areaid to function as an NSSA.
Format
area <areaid> nssa
Mode
Router OSPF Config
ProSafe Managed Switch
Routing Commands
270