List Critical Events; List Dns Hosts; List Dns Servers; List Facilities - 3Com OfficeConnect 3CP4144 Cli User's Manual

B-18 A B: CLI COMMAND DESCRIPTION
PPENDIX

list critical events

list dns hosts

list dns servers

list facilities

list filters

list files

list interfaces

list ip addresses

list ip arp

Displays the last ten critical status events, and the system time when each
occurred. You can change which events are logged as critical, using the set facility
command. The table displays the system, the up time, and the event.
Displays the DNS Local Host name and its IP address, which you configured using
the add dns host.
Displays DNS Name Servers, which you configured using the add dns server
command. The domain name and the server address are listed for each DNS
server.
Displays the system facilities (processes) currently running, plus the default log
level. The log level is the severity of error that facility will produce syslog entries for.
You can change the log level using the set facility loglevel command.
Displays all the filter names in the filter table, which you previously defined using
the add filter command. You can remove filters using delete filter. The command
lists the filter file name, the status of the filter, and the protocols the file applies to.
For example:
Filter Name Status
easyfilter.fil NORMAL
Displays the files currently stored in the FLASH file system. You can remove files
using delete file, but you can add them using TFTP only.
Displays the installed interfaces, along with their operational status, administration
status, and interface index. If an interface is down, you can use enable interface to
try to bring it up. The command lists:
Index - number used to identify the interfaces position in the table
Name - interface name: eth:1, DA:1 or loopback
Oper Status - current, operating status of interface; UP or DOWN
Admin Status - administrative status you designated interface to be, up or
down. If it doesn't match Oper Status, a problem exists with the interface.
Displays the IP address for each interface. It lists:
Address - IP address of the interface
Bcast Algo - broadcast algorithm used
Reassembly Max Size - maximum allowable size of packet that can be
reassembled from a fragmented packet
Interface - interface this IP address uses to connect to the system
Displays the contents of the ARP cache. It lists:
IP Address - IP address for this entry
Phys Address - MAC address that the IP address maps to
Protocols
IP IP-RIP