Connecting A Signaling Server To The Elan Subnet - Nortel 1000E Installation And Configuration Manual

Page 162 of 488

Connecting a Signaling Server to the ELAN subnet

Figure 43
Signaling Server ELAN and TLAN network interfaces
553-3041-210 Standard 4.00
Connecting MG 1000T system components
Follow Procedure 36 to connect a Signaling Server to the ELAN subnet.
Procedure 36
Connecting a Signaling Server to the ELAN subnet
1 Connect one end of a standard CAT5 cable to the ELAN network interface
(bottom) on the back of the Signaling Server as shown in Figure 43.
2 Connect the other end of the standard CAT5 cable to an RJ-45 ELAN
network interface on the ELAN Layer 2 switch (BayStack 470-24T).
September 2007
TLAN
ELAN
End of Procedure