Retrieving Cdr Records From A Survivable Mg 1000T Expansion - Nortel 1000E Installation And Configuration Manual

Page 476 of 488
Retrieving CDR records from a survivable MG 1000T
Expansion
553-3041-210 Standard 4.00
Configuring MG 1000T survivability and alternate primary controller
The XCDR command, file retrieval in LD 143, transfers the CDR file from
the survivable
MG 1000T Expansion
.
MG 1000T Core
Use the following procedure to retrieve the CDR files stored on the survivable
MG 1000T Expansion
Procedure 122
Retrieving CDR files using XModem
1 Connect a PC to the MG 1000T Core either remotely using a modem or
directly using an SDI cable and a modem eliminator. Using a
terminal-emulation program such as Hyperterminal, establish a TTY
session with the MG 1000T through the modem or SDI cable.
2 Log in and access LD 143 on the MG 1000T Core.
3 Enter the following command: XCDR
The system prompts for the MG 1000T Expansion number.
4 Enter the MG 1000T Expansion number on which the <dba.cdr> file is
stored.
The system prints the following.
Getting CDR file for EXP_CAB <num>
Ready to transmit
5 Select the XModem protocol on the PC to receive the CDR file.
Use the Hyperterminal transfer function to receive the file using XModem
protocol. Rename the file to indicate which MG 1000T Expansion the
CDR data is from.
Note: Use a filename that does not overwrite any DBA-specific files if
DBA is used to retrieve CDR/Traffic files from the MG 1000T.
6 Parse the CDR file into the MG 1000T's database on the PC. Refer to the
OTM NTPs for how to process CDR records for billing applications.
September 2007
directly to the PC connected to the
(one file in each
MG 1000T Expansion
End of Procedure
).