To Connect The Server To The Elan; Connecting The Server To The Elan - Nortel CallPilot 1002rp Hardware Installation Manual

Installing the server and connecting the peripheral devices

Connecting the server to the ELAN

Introduction
ATTENTION
Connect the CallPilot server to the Meridian 1 switch or Succession 1000
system using the ELAN.
ATTENTION
ATTENTION
Media Access Control address
The Media Access Control (MAC) address is a unique number assigned to
network cards and controllers. The procedure below asks you to record the
ELAN MAC address. The MAC address is recorded on a label affixed to the
back of the chassis.

To connect the server to the ELAN

1 See the diagram on page 65 to locate the ELAN Ethernet connector.
2 Locate the MAC address label on the back of the chassis that identifies
the ELAN controller MAC address.
68
This section applies only if the 1002rp server connects
to a Meridian 1 switch or Succession 1000 system.
For important considerations about using the ELAN in
your network, see the Planning and Engineering Guide
(555-7101-101).
To comply with EMC radiation requirements, a Class A
hub must be located 10 m (33 ft.) away from the 1002rp
server. Shielded Ethernet cables must be used.
Standard 1.07
CallPilot