Nortel 1000E Installation And Configuration Manual page 362

Page 362 of 488
Figure 127
AUX cable connector
553-3041-210 Standard 4.00
Installing the Main Distribution Frame
4 Tighten the velcro straps when you have connected each cable to the
system.
5 Terminate all the 25-pair cables installed at the cross-connect terminal.
6 Label all the cables at the cross-connect terminal blocks according to the
card slot assignment plan.
7 Connect the AUX cable in the upper 9-pin connector located on the top
left-hand side of the Media Gateway. See Figure 127 on
AUX
September 2007
page 362.