Nortel 1000E Installation And Configuration Manual page 243

Installing software on an MG 1000T Small System Controller
feature sets. The Software Installation Program also enables administrators to
add individual packages from the feature set and change ISM system
parameters.
Additions and changes are keycode controlled. Therefore, the packages and
licenses must match those corresponding to the site's keycodes.
Note: The Software Installation Program does not check the
prerequisites and interactions of added packages.
AUX ID
Enter the AUX ID using the Software Installation Program. For new
CS 1000E sites, the AUX ID is the system security ID.
Customer database
The Software Installation Program enables an administrator to install a
customer database from one of the following sources:
• Preconfigured database — The Software Delivery card can include
several preconfigured databases and their associated feature sets. In
addition, a minimal database is provided containing basic system
configuration information with no customer data.
• Archived database — The Software Installation Program enables the
archiving of various databases which can be used later at CS 1000E sites.
It also enables multiple databases to be configured off-site and then
installed ready-to-use at customer sites.
• Off-site programming of databases is subject to all security keycode
restrictions. The off-site system must either use the Security Device that
is installed in the CS 1000E system at the customer site, or must have its
own keycodes for the feature set used.
• Remote restored database — A database can be restored remotely using
the LD 143 CCBR remote restore command.
• Backed up database — This option enables the copy on the backup flash
drive to be installed. It is provided to recover a customer database if the
customer database on the primary flash drive becomes corrupted.
Communication Server 1000E
Page 243 of 488
Installation and Configuration