Page 278 of 488
Checking the status of the ELAN network interfaces
553-3041-210
Standard 4.00
Verifying the network
Follow Procedure 71 to check the status of the ELAN network interfaces.
Note: IP addresses used are for example only.
Procedure 71
Checking the status of the ELAN network interfaces
1
Observe the ELAN Ethernet LEDs (Layer 2 network link) on all Media
Gateway SSC cards. See Figure 94 on
a.
If the ELAN LED is green, the Link is established.
b.
If the Link LED is not lit, check all cable connections to ensure that
they are connected correctly, and not damaged.
The ELAN red and yellow LEDs flash when there is network activity.
Note: Cards in slot 1 can make viewing difficult.
September 2007
page
284.