Configuring The Mg 1000E Bandwidth Management Zones - Nortel 1000E Installation And Configuration Manual

Configuring the MG 1000E Bandwidth Management Zones

Configuring the CS 1000E Call Server
Follow Procedure 52 for configuring bandwidth management zones.
Procedure 52
Configuring MG 1000E Bandwidth Management Zone
1 Enter LD 117 and press <cr>.
2 Enter NEW ZONE 0, to create a new zone with default parameters.
Note: LD 117 also includes DIS and ENL commands to disable or enable
a zone. When you create a zone, its default state is enabled. See LD 117
– Bandwidth management zone commands on
3 Print zone and bandwidth information using PRT INTRAZONE or PRT
INTERZONE.
4 Exit from LD 117 by entering the command: ****
Communication Server 1000E
Page 211 of 488
page 212.
Installation and Configuration