Nortel 1000E Installation And Configuration Manual page 292

Page 292 of 488
553-3041-210 Standard 4.00
Installing and cross-connecting a trunk card
Before you proceed, install the cable from the slot that contains the Line card
associated with the telephone being connected. Refer to "Installing the Main
Distribution Frame" on
DANGER OF ELECTRIC SHOCK
Always use caution when installing or modifying
telephone lines. Do not install telephone wiring during a
lightning storm. Do not install telephone jacks in wet
locations unless the jacks are designed for wet locations.
Never touch uninsulated telephone wiring unless the line
is disconnected at the network interface.
Refer to the Circuit Card: Description and Installation (553-3001-211) for
full descriptions of country-specific circuit cards and their installation
procedures.
CAUTION WITH ESDS DEVICES
Always handle circuit cards with caution to avoid damage
caused by static electricity. Always store circuit cards that
are not in use in an antistatic bag or the original
packaging
Wear an antistatic wrist strap, such as the one shown in
Figure 98 on
Static electricity can damage circuit card components.
September 2007
page 353, if you require additional cable installation.
page 293, when handling circuit cards.