Installing Software On An Mg 1000E Ssc - Nortel 1000E Installation And Configuration Manual

Page 236 of 488

Installing software on an MG 1000E SSC

553-3041-210 Standard 4.00
Installing software on an MG 1000E Small System Controller
The MG 1000E is shipped with a pre-programmed software daughterboard
that must be mounted on the SSC.
Before proceeding, ensure that the required hardware is correctly
installed and that all connections are secure.
Procedure 59
Installing software on an MG 1000E SSC
1 Confirm that the outlet is providing the correct voltage. Refer to the label
at the back of the equipment.
2 Connect the power cord from the power connectors at the back of the
MG 1000E to an AC power source.
3 Ensure that the system terminal (TTY) is connected to the cable marked
"port 0" on the NTBK48 3-port cable of the Media Gateway.
4 Turn the Media Gateway power switch to "ON".
System response:
Current system time and date :
2/14/2096 6:19:00
Enter new time (hh:mm:ss) : 14:41:00
Enter new date (mm/dd/yy) : 06/03/04
14:41:0 -- 6/3/2004 is the new system time and date.
Is this correct? (y/n/[a]bort) : y
q]uit, [h]elp or [?], <cr> - redisplay
September 2007
IMPORTANT!