Configuring A Card As A Node Leader; Configuring Voice Gateway Channels Using Element Manager - Nortel 1000E Installation And Configuration Manual

Configuring a card as a node Leader

Configuring voice gateway channels using
Element Manager
Installing and configuring a Voice Gateway Media Card
A Voice Gateway Media Card remains at the default "Follower" setting in a
CS 1000E system. A Signaling Server is the IP telephony node Leader.
In an IP telephony node without a Signaling Server, one of the Voice
Gateway Media Cards must be configured as a Leader. If this is your
configuration, see the IP Line: Description, Installation, and Operation
(553-3001-365) for a detailed configuration procedure.
Normally, Voice Gateway Media Cards default as Followers. If you need to
configure a Voice Gateway Media Card as a Follower, see the IP Line:
Description, Installation, and Operation (553-3001-365) for a detailed
configuration procedure.
The voice gateway channels are also called "DSP channels" or the card's
"physical TNs". Follow Procedure 77 to configure the voice gateway
channels using Element Manager.
Note: The voice gateway channels can also be configured using LD 14.
To configure the voice gateway channels using LD 14, follow
Procedure 78 on
Procedure 77
Adding voice gateway channels using Element Manager
1 Select IP Telephony > Nodes: Servers, Media Cards > Configuration
from the navigator.
The Node Configuration web page opens, as shown in Figure 99 on
page 322.
2 Click the + next to the desired node to expand it.
3 Click VGW Channels next to the desired card.
If no VGW channels are configured yet, an alert box is displays. Click OK
to close the alert box.
Communication Server 1000E
page 328.
Page 325 of 488
Installation and Configuration