Nortel 1000E Installation And Configuration Manual page 478

Page 478 of 488
Flow charts
553-3041-210 Standard 4.00
Basic system telephony configuration
See Software Input/Output: Administration (553-3001-311) for information
about overlays.
Figure 160 on page 481
new system. The Data-entry-sequence flowchart does not show all possible
administration overlays.
In some cases, you must move back and forth between overlays to complete
the programming. For example, you must program the Customer Data Block
(CDB) before you program the attendant console. However, there are
console-related prompts in the CDB that cannot be programmed until you
have programmed an attendant console. Skip the console-related prompts,
complete the CDB programming, then return to the CDB after the console is
programmed. Finish the CDB console-related prompts. A similar situation
exists with the Speed Call lists and the Telephones. You must activate the
Speed Call list(s) before you can assign the list(s) to a telephone.
Figure 161 on page
gate openers for each feature group. A gate opener enables users to program
a related group of features without stepping through all prompts of an overlay.
NTP references are shown in the flowchart shaded boxes for those features
and options beyond the scope of this guide.
Procedure 1
Configuring the basic system
Use the overlays to configure basic system features offered by the CS 1000E.
1 Complete the configuration using the overlays in the order shown in
Figure 160 on page
page 483.
September 2007
shows the programming overlay (LD) sequence for a
482, and Figure 162 on
481, Figure 161 on
page 483 show overlay titles and
page 482, and Figure 162 on