Introduction; Installing The Main Distribution Frame - Nortel 1000E Installation And Configuration Manual

Installing the Main Distribution Frame

Contents

Introduction

This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Terminal block requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing a BIX cross-connect terminal . . . . . . . . . . . . . . . . . . . . . . . .
Installing a Krone Test Jack Frame for the UK . . . . . . . . . . . . . . . . . .
Connecting the cables to the Media Gateways . . . . . . . . . . . . . . . . . . .
This chapter describes how to install and connect a CS 1000E system using
the BIX, or Krone Test Jack Frame (UK) cross-connect terminals.
This chapter contains the following procedures:
1 Procedure 89: "Installing a BIX cross-connect terminal" on
2 Procedure 90: "Installing the Krone Test Jack Frame (UK)" on
3 Procedure 91: "Connecting the cables to the Media Gateways" on
page 360.
Note: The use of the BIX system is not mandatory; however, it is the
recommended option.
Communication Server 1000E
Page 353 of 488
page
page
Installation and Configuration
353
354
354
356
360
354.
358.