Nortel 1000E Installation And Configuration Manual page 419

Figure 146
Node Password
10 Click SET.
The administrator password is set and enabled.
Note: The entered password appears as asterisks. The valid characters
are 0-9 * #. The password can be null or 6 to 14 digits in length.
WARNING
If the administrator password is null (zero length), then
the Node ID, TN, and Password screens are not
displayed on the IP Phones during their registration
process. This provides security as it prevents any entry
of passwords or TNs on the IP Phones. However, it is
impossible to install new IP Phones (unless a temporary
password is set).
11 Select NodePwd from the Group drop-down list.
12 Select nodePwdShow from the Command drop-down list.
13 Click RUN.
The updated administrator IP Phone Installer Password is displayed in the
text area at the bottom of the web page.
14 Enter the temporary IP Phone Installer Password (see
Figure 147):
a. Enter the password in the Node Password text box.
b. Select NodePwd from the Group drop-down list.
c. Select nodeTempPwdSet from the Command drop-down list.
The area then displays the Uses and Timeout text boxes.
d. Enter a value for the number of uses or a value for timeout (in hours)
or both.
Communication Server 1000E
Installing and configuring IP Phones
Page 419 of 488
Installation and Configuration