Signaling Server Sdi Connection - Nortel 1000E Installation And Configuration Manual

Signaling Server SDI connection

Figure 89
Signaling Server maintenance port locations
Front port
Configuring a terminal and SDI ports
The Signaling Server has two maintenance ports: the Front port and the
Console port (see Figure 89). The Console port must be used to install the
Signaling Server software to perform the basic configuration.
Procedure 70
Connecting the maintenance PC to a Signaling Server
1 Connect a DTE–DTE null modem serial cable (supplied with the Signaling
Server) from the Console port to a PC workstation.
Note: The Signaling Server is shipped with the Admin/Serial port set to
19200 bit/s.
During the initial installation, the unit requires the PC Maintenance
terminal settings as provided in Step 2 on page 274.
Communication Server 1000E
Page 273 of 488
Console port
Installation and Configuration