Configuring Voip Bandwidth Management Zones - Nortel 1000E Installation And Configuration Manual

Configuring VoIP bandwidth management zones

• Procedure 114: "Displaying registered IP Phones in Element Manager"
on page 439
Follow Procedure 102 to configure the VoIP bandwidth management zones.
For more details on bandwidth management zones, see IP Line: Description,
Installation, and Operation (553-3001-365).
VoIP bandwidth management zones can be configured with Element
Manager or using the CLI. For more information about Element Manager, see
Element Manager: System Administration (553-3001-332).
Procedure 102
Configuring VoIP bandwidth management zones using the CLI
1 Log in to the Call Server.
a. Enter the command:
LOGI
System response:
PASS?
b. Enter the default password:
0000
2 Access LD 117. Enter the command:
LD 117
3 Create a new zone with default parameters. Enter the command:
NEW ZONE 0
Note: LD 117 also includes DIS and ENL commands to disable or enable
a zone. When you create a zone, its default state is enabled. See
Table 50 on page 409
4 Print zone and bandwidth information. Enter the command:
PRT ZONE.
Communication Server 1000E
Installing and configuring IP Phones
for the LD 117 zone commands.
Page 408 of 488
Installation and Configuration