Entering Ip Phone Boot Parameters Using Manual Configuration - Nortel 1000E Installation And Configuration Manual

Entering IP Phone boot parameters
using manual configuration
Follow Procedure 107 to enter IP Telephone boot parameters using manual
configuration.
Procedure 107
Entering IP Telephone boot parameters using manual configuration
1 Power the IP Phone.
Within four seconds, the Nortel logo appears.
2 When the Nortel logo appears on the display, you have one second to
press the four feature keys at the bottom of the display in sequence, from
left to right.
Note: If the Nortel logo times out, repeat step 1 and step 2.
3 For the following prompts:
a. Press the BKSpace (backspace) or Clear keys to change an entry.
b. Enter new values using the telephone's keypad.
c. Press the OK key to accept your selection.
The IP Phone prompts:
DHCP? (0-No, 1-Yes): 0
4 Enter 0 for manual boot parameter configuration.
The IP Phone prompts:
SET IP: x.x.x.x
5 Enter the IP Phone IP address.
The IP Phone prompts:
NETMSK: x.x.x.x
6 Enter the subnet mask.
The IP Phone prompts:
DEF GW: x.x.x.x
Communication Server 1000E
Installing and configuring IP Phones
Page 425 of 488
Installation and Configuration