Nortel 1000E Installation And Configuration Manual page 173

Installing and configuring the Signaling Server software
3 If this is a re-installation on an existing system, observe the boot
sequence. Enter c at the boot menu shown in Figure 47.
Note: Entering c in the "ISP1100 System Boot" banner screen speeds up
this process, as the keyboard input is buffered.
Figure 47
Upgrade boot sequence
ISP1100 System Boot
Copyright 2002-2004 Nortel Networks, Inc.
CPU: PC PENTIUM
Version: x
BSP version: 1.2/0
Creation date: Apr 22 2004, 15:44:38
ataDrv 1.0: ATAPI Drive Found
Controller 1 drive 0
Controller 1 drive 1
ATAPI Controller 1 #drives found = 1
Read boot parameters from:
[C]DROM
[H]ard Disk
5 [H]
Note: If you do not select c within the ten-second time-out, the Signaling
Server boots to the existing software on the hard disk.
4 Enter b at the menu shown in Figure 48 on
Communication Server 1000E
Page 173 of 488
page 174.
Installation and Configuration