Nortel 1000E Installation And Configuration Manual page 375

Note 1: Clicking Transfer / Status displays the Transfer / Status web
page (see Figure 137 on
files to all IP Telephony components in the node.
• If any element within the node fails to transfer either BOOTP or
CONFIG files, Transfer / Status is highlighted in red.
• Transfer / Status is highlighted in yellow if the transfer status of the
node elements is unavailable.
Note 2: Delete is used to delete the corresponding node. The node is not
automatically deleted. A message displays and asks if you are sure you
want to delete the node.
2 Review the node parameters by opening each tab.
Note: For detailed information on each of the node parameters, refer to
IP Line: Description, Installation, and Operation (553-3001-365).
3 Click Save and Transfer.
4 Click OK to save the node configuration to the CS 1000E and transfer the
configuration to all elements.
After a few seconds, the Transfer Progress web page opens and
displays each of the elements in the node (see Figure 134 on
The Voice Gateway Media Cards retrieve the CONFIG.INI and
BOOTP.TAB files from the CS 1000E. A check mark is added to each
field as the card receives its CONFIG.INI and BOOTP.TAB files.
The status column provides the progress of the transfer:
• The Status column displays "Starting" as the transfer begins (see
Figure 134 on
• The Status column displays "Transfer" as the node configuration is
transferred to the elements (see Figure 135 on
• The Status column displays "Complete" if the transfer is successful
for an element (see Figure 136 on
• The Status column displays "Fail" if the transfer is unsuccessful.
Communication Server 1000E
Configuring an IP telephony node
page 378). This sends the node configuration
page 376).
Page 375 of 488
page 376).
page 377).
Installation and Configuration
page 376).