Nortel 1000E Installation And Configuration Manual page 422

2 Connect one end of the CAT5 line cable to the Ethernet jack at the back
of the telephone. See Figure 148 on
3 Connect the other end into the IP voice network (Ethernet), using an
RJ-45 connector. See Figure 149 on
WARNING
Do not plug the IP Phone into an ISDN connection.
Severe damage can result. Consult the system
administrator to ensure that the telephone is being
plugged in to a 10/100BaseT Ethernet jack.
4 Power the IP Phone with one of the following methods:
a. Using a 16V AC power adaptor, plug the AC power transformer into
the nearest power outlet. Check the IP Phone User Guide for
country-specific parameters.
b. Using a Power over LAN unit, connect the Power over LAN unit as
shown in Figure 149 on
5 Secure the telephone footstand to the base of the telephone. Use the
angle adjustment grip on the top rear of the telephone to adjust the
position.
Communication Server 1000E
Installing and configuring IP Phones
page 423.
Page 422 of 488
page 421.
page 423.
Installation and Configuration