Installing An Alarm Using An Alarm Port Assigned In Ld - Nortel 1000E Installation And Configuration Manual

Page 456 of 488

Installing an alarm using an alarm port assigned in LD 15

Table 60
LD 15 – Assign an alarm port.
Prompt Response
REQ CHG
TYPE CDB
CUST xx
...
ALDN x...x
553-3041-210 Standard 4.00
Installing and cross-connecting an external alarm from a PFTU
The system can be equipped with an alarm port that is assigned in software.
Connect an analog line to an analog (500/250-type) telephone or another
similar type of ringing or alerting device.
Follow Procedure 118 to install an alarm using an alarm port assigned in
LD 15.
Procedure 118
Installing an alarm using an alarm port assigned in LD 15
1 Install an analog (500/2500-type) line as described in "Installing and
configuring IP Phones" on
2 Connect an analog (500/2500-type) telephone, or another similar alerting
device used as an alarm, to the line.
3 Use LD 15 to assign an alarm port, (see Table 60).
Note: If the DN assigned to the alarm is accidentally called, the alarm
activates. To avoid false alarms, make sure the DN is not already
assigned.
Comment
Change existing data
Customer Data Block
Customer Number as defined in LD 15
Alarm Directory Number
September 2007
page 395.
End of Procedure