Nortel 1000E Installation And Configuration Manual page 407

Connectivity and power requirements
Each IP Phone requires:
• a dedicated 10BaseT or 100BaseT or 10/100BaseT Ethernet interface
• a small desktop hub or switch if sharing an existing desktop Ethernet
connection with a PC.
• a local power supply appropriate for the voltage in the area or a Power
over LAN unit. (The IP Phone 2002 comes with a built-in 3-port switch
and is ready for LAN powering.)
Installation and configuration procedures
This chapter contains the following procedures:
• Procedure 102: "Configuring VoIP bandwidth management zones using
the CLI" on
• Procedure 103: "Configuring virtual superloops" on
• Procedure 104: "Configuring the IP Phones" on
• Procedure 105: "Setting passwords for the administrator and temporary
IP Telephone Installer" on
• Procedure 106: "Installing IP Phone hardware components" on
• Procedure 107: "Entering IP Telephone boot parameters using manual
configuration" on
• Procedure 108: "Entering IP Phone boot parameters using full DHCP
parameters" on
• Procedure 109: "Entering IP Phone boot parameters using partial DHCP
parameters" on
• Procedure 110: "Using Set-Based Installation" on
• Procedure 111: "Configuring the IP Softphone 2050" on
• Procedure 112: "Installing the USB Headset Kit" on
• Procedure 113: "Installing the IP Softphone 2050 on your PC" on
page 437
Installing and configuring IP Phones
page 408
page 417
page 425
page 428
page 430
Communication Server 1000E
Page 407 of 488
page 410
page 411
page 433
page 436
page 437
Installation and Configuration
page 420