Configuring a terminal and SDI ports
Contents
Introduction
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
In the CS 1000E system, each stand-alone module (Call Server, MG 1000E,
MG 1000T, Signaling Server, and Baystack switch) has a Serial Data
Interface (SDI) port to be used for software installation and maintenance
access. The SDI port can be accessed by running a Telnet session through the
Terminal Server locally or remotely. See "Configuring a Terminal Server" on
page 255
for Terminal Server Setup. The SDI port can also be accessed by a
local terminal through the SDI connection.
Communication Server 1000E
Page 267 of 488
Installation and Configuration
267
268
268
269
270
270
273
274
274