Nortel 1000E Installation And Configuration Manual page 151

Switch call processing
Procedure 32
Switching call processing
LD 135
SCPU
Call Server 1 is now the active call processor.
Perform a customer backup data dump (installation release)
Procedure 33
Performing a data dump to backup the customer database:
1 Log in to the system.
2 Insert a CF card into the active Call Server RMD slot to back up the
database.
3 Load the Equipment Data Dump Program (LD 43). At the prompt, enter:
LD 43
.
4 When "EDD000" appears on the terminal, enter:
EDD
CAUTION — Service Interruption
Loss of Data
If the data dump is not successful, do not continue;
contact your technical support organization. A data
dump problem must be corrected before proceeding.
Communication Server 1000E
Installing software on the CS 1000E
Load program
Switch call processing from Call Server 0
to Call Server 1
End of Procedure
Load program.
EDD
Begin the data dump.
Page 151 of 488
Installation and Configuration