Enabling A Card - Nortel 1000E Installation And Configuration Manual

Enabling a card

Installing and configuring a Voice Gateway Media Card
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 121 on page
4 Select the DISU – Disable unit command from the Unit Commands
drop-down list.
5 Enter the card number and unit number in the corresponding Command
Parameter text box.
6 Click Submit to the right of the text box.
The output from this command is shown in the text box in the lower half
of the web page.
Follow Procedure 87 to enable a Voice Gateway Media Card using
Element Manager.
Procedure 87
Enabling a Voice Gateway Media Card using Element Manager
1 Select System > Maintenance from the navigator.
The Maintenance web page opens as shown in Figure 119 on
This page allows you to perform maintenance using overlays or using a
selected functionality. The default is overlay, as shown in Figure 119.
2 Select Select by Functionality.
The list in the web page changes to show a list of diagnostics you can use,
as shown in Figure 120 on
3 Select Network & Peripheral Equipment Diagnostics from the list in
Figure 120 on page
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 121 on page
4 Select the ENLC – Enable and reset card command from the Card
Commands drop-down list.
5 Enter the card number in the corresponding Command Parameter text
box.
6 Click Submit to the right of the text box.
Communication Server 1000E
346.
End of Procedure
page 345.
345.
346.
Page 349 of 488
page
Installation and Configuration
344.