Nortel 1000E Installation And Configuration Manual page 47

Table 2
Signaling Server profile (Part 2 of 2)
Property
Connectors
(front)
Connectors
(rear)
CAUTION — Service Interruption
Do not connect maintenance terminals or modems to
the faceplate and I/O panel DB-9 male serial
maintenance port at the same time.
For detailed information about the Signaling Server, refer to Signaling
Server: Installation and Configuration (553-3001-212).
Communication Server 1000E
System components
Description
• The DB-9 serial port, the CD-ROM and floppy
drives are located on the unit's faceplate.
• The DB-9 serial port can support a login session
for Command Line Interface (CLI) management.
• See Figure 4 on page
• The TLAN network interface (P2) connects the
unit to a TLAN network interface on a Layer 2
Switch.
• The ELAN network interface (P1) connects the
unit to an ELAN network interface on a Layer 2
Switch.
• The DB-9 serial port can support a login session
for Command Line Interface (CLI) management.
• There are three ports not used for any CS 1000E
system function. Do not plug any device into these
ports.
• See Figure 5 on page
Page 47 of 488
48.
49.
Installation and Configuration