Nortel 1000E Installation And Configuration Manual page 170

Page 170 of 488
Signaling Server Software CD-ROM
553-3041-210 Standard 4.00
Installing and configuring the Signaling Server software
To perform a software installation or upgrade, reboot the Signaling Server
with the Software CD-ROM in its drive. No floppy disk is required, since the
Software CD-ROM is bootable.
The Install Tool installs all Signaling Server software, including the operating
system, applications, and web files. The Install Tool also copies software files
for the Voice Gateway Media Cards and IP Phones, which are used to
upgrade these components. For a new installation, the Install Tool prompts
for IP Telephony parameters to perform basic system configuration.
After installing the Signaling Server software and configuring basic
information about the Signaling Server, the Signaling Server components can
be configured using the web-based Element Manager interface. Refer to
Element Manager: System Administration (553-3001-332).
If you do not have the latest version of the CD-ROM:
• Order or download the CD-ROM image from the Nortel Electronic
Software Download site. See Procedure 42 for instructions on
downloading the image.
• Create the Install Tool CD-ROM from the image. See Procedure 43 on
page 171.
A single ".iso" file is provided to create the Software CD-ROM. This file is a
ready-to-burn ISO9660 CD image that creates a bootable CD that complies
to the El Torito specification. You must use CD writer software that can
create a CD from this image. As the CD image is preconfigured, your
software automatically creates a bootable CS 1000 Release 4.5 CD-ROM.
See your software help pages to create a CD from an ISO file. Also review
the associated README file that is associated with the Nortel Signaling
Server Software download.
Procedure 42
Downloading the Signaling Server CD image
1 Connect to the Nortel website at www.nortel.com.
2 Navigate to the Software Downloads page.
September 2007