Connecting The Server To The Elan Subnet - Nortel NN44200-300 Hardware Installation

7
8
What is next?
Continue with

Connecting the server to the ELAN subnet

Introduction
This section applies only if the 1002rp server connects to a Meridian 1 switch or
Communication Server 1000 system.
Connect the CallPilot server to the Meridian 1 switch or Communication
Server 1000 system using the ELAN interface.
For important considerations about using the ELAN subnet in your network, see
the CallPilot Planning and Engineering Guide (NN44200-306).
To comply with EMC radiation requirements, a Class A hub must be located 10 m
(33 ft.) away from the 1002rp server. Shielded Ethernet cables must be used.
Media Access Control address
The Media Access Control (MAC) address is a unique number assigned to
network cards and controllers. The procedure below asks you to record
the ELAN MAC address. The MAC address is recorded on a label affixed
to the back of the chassis.
To connect the server to the ELAN subnet
Step
1
Copyright © 2007, Nortel Networks
.
the power outlets of the CallPilot server and the power outlets of
the switch.
Connect the power cord to the modem, and plug the other end into
a wall receptacle or power bar.
Note: Ensure that the power source is consistent with the SBC
for all ancillary equipment.
Turn on the modem.
"Connecting the server to the ELAN subnet" (page
Action
See the diagram on page
locate the ELAN Ethernet connector.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
Connecting the server to the ELAN subnet 49
—End—
ATTENTION
ATTENTION
ATTENTION
"Rear panel connectors" (page 47)
49).
to
Nortel Networks Confidential