Rack-mounting the components
Page 84 of 488
Figure 20
Chassis support bracket
553-3041-210
Standard 4.00
Note: The Front Mount Bracket assembly is not intended for use as a
slide rail system. The Signaling Server must be firmly attached to the rack.
WARNING
2
Align the end of the rail with the flange (B) toward the rear of the Signaling
Server. See Figure 20 on
3
Align the screw holes in the rack-mount rail to the mating holes in the side
of the Signaling Server chassis. Use three screws (C) on each side.
Note: Hand-tighten the screws to prevent cross-threading, then use a
Phillips screwdriver to secure them.
4
Attach the bezel door to the faceplate of the Signaling Server, as shown
in Figure 21 on
September 2007
page
84.
page 85
and Figure 22 on
page
85.