Installing and configuring a Voice Gateway Media Card
4
Insert the CompactFlash card in the socket.
Press firmly until it is fully seated and the Eject button extends (see
Figure 109).
Figure 109
Insert CompactFlash to extend Eject button
5
Turn the Voice Gateway Media Card over to view the back of the card.
Identify the hole for the Retaining Pin. The hole (labeled a in Figure 110)
is located approximately 1 inch (2.5 cm) above the lower lock latch and
1 inch (2.5 cm) from the card's faceplate.
Figure 110
Retaining Pin hole
6
Insert the Retaining Pin in this hole (labeled 1 in Figure 111).
Communication Server 1000E
Page 333 of 488
Eject button
Installation and Configuration