Entering Ip Phone Boot Parameters Using Full Dhcp Parameters - Nortel 1000E Installation And Configuration Manual
Nortel 1000e server: install guide
Hide thumbs
Also See for 1000E:
- Upgrade (230 pages) ,
- Maintenance manual (222 pages) ,
- Regulatory and safety information (2 pages)
Table of Contents
Advertisement
Entering IP Phone boot parameters
using full DHCP parameters
17 Enter the IP Phone's (virtual) TN.
The IP Phone displays the logo, the date and time, and the DN keys.
18 Check for dial tone and the correct DN above the display.
Follow Procedure 108 to enter IP Phone boot parameters using full DHCP
parameters.
Procedure 108
Entering IP Phone boot parameters using full DHCP parameters
1
Power the IP Phone.
Within four seconds, the Nortel logo appears.
2
When the Nortel logo appears on the display, you have one second to
press the four feature keys at the bottom of the display in sequence, from
left to right.
Note: If the Nortel logo times out, repeat step 1 and step 2.
3
For the following prompts:
a.
Press the BKSpace (backspace) or Clear keys to change an entry.
b.
Enter new values using the telephone's keypad.
c.
Press the OK key to accept your selection.
The IP Phone prompts:
DHCP? (0-No, 1-Yes): 0
4
Enter 1 to use DHCP.
The IP Phone prompts:
DHCP:0-Full, 1-Partial:0
5
Enter the 0 to use Full DHCP.
The IP Phone prompts:
VLAN?(0-No,1-Ma,2-Au)0
Communication Server 1000E
Installing and configuring IP Phones
End of Procedure
Page 428 of 488
Installation and Configuration
Advertisement
Chapters
Table of Contents
