Connecting A Media Card To The Tlan Subnet; Connecting A Media Gateway To A Media Gateway Expansion - Nortel 1000E Installation And Configuration Manual

Page 166 of 488

Connecting a Media Card to the TLAN subnet

Connecting a Media Gateway to a
Media Gateway Expansion
553-3041-210 Standard 4.00
Connecting MG 1000T system components
Follow Procedure 40 to connect a Media Card to the TLAN subnet.
Procedure 40
Connecting a Media Card to the TLAN subnet
1 Connect a standard CAT5 patch cable to the TLAN network interface on
the Adaptor (see Figure 45 on
2 Connect the other end of the standard CAT5 patch cable to an RJ-45
TLAN network interface on the BayStack 470 switch.
Procedure 41 describes how to connect a Media Gateway Expander to the
Media Gateway. The Media Gateway Expander Cable Kit (NTDK89)
contains two NTDK95 cables used to connect the Media Gateway Expander
to the Media Gateway. One cable provides DS-30X connectivity while the
second cable provides CE-MUX connectivity to slot 10 only.
Procedure 41

Connecting a Media Gateway to a Media Gateway Expansion

1 Connect one NTDK95 cable from the CE-MUX connector on the back of
the Media Gateway to the CE-MUX connector on the back of the Media
Gateway Expander.
2 Tighten the screws on the connectors.
3 Connect the other NTDK95 cable from the DS-30X connector on the back
of the Media Gateway to the DS-30X connector on the back of the Media
Gateway Expander.
4 Tighten the screws on the connectors. Figure 46 on
Media Gateway and Media Gateway Expander connected with the two
NTDK95 cables.
September 2007
page 165).
End of Procedure
page 167 shows the