Connecting The 201I Server To The Switch, Elan, And Clan - Nortel CallPilot Installation And Configuration Manual
Hide thumbs
Also See for CallPilot:
- Install manual (286 pages) ,
- Administrator's manual (250 pages) ,
- User manual (182 pages)
Table of Contents
Advertisement
Installing the server and connecting the peripherals
Connecting the 201i server to the switch, ELAN,
and CLAN
Introduction
The CLAN and ELAN connections are established by using the 201i server's multi
I/O cable. The CLAN and ELAN connectors support the following network
protocols:
CLAN: 10- or 100Base-T Ethernet
ELAN: 10Base-T Ethernet
See the following diagram:
Multi I/O cable NTRH0912
R-45 female-to-female gender change jack
Note: If you need more than 3 m (10 ft) of multi I/O cable, use the supplied R-45
female-to-female gender change jacks to attach additional cable. A maximum of
76.2 m (250 ft) is supported.
110
Standard 1.0
Drain wire
50-pin
amphenol
connector
ELAN
connector
CLAN
connector
RS-232
connector
G101441
CallPilot
Advertisement
Table of Contents
