Nortel 1000E Installation And Configuration Manual page 141

3 Wait for "DONE" and then "INI" messages to display before you continue.
Test the Call Server
Procedure 26
Testing the Call Server
1 Verify that the Call Server is active.
LD 135
STAT CPU
2 Check dial-tone.
3 Verify that the Call Server is active, redundant, and single.
4 Make internal, external, and network calls.
5 Check attendant console activity.
6 Check IP Peer networking for incoming and outgoing calls.
7 Check applications (CallPilot, Symposium, and so on).
Install the software on the second Call Server
Procedure 27
Installing the software on the second Call Server
1 Attach the LAN 1 and LAN 2 cables to the CP PIV faceplate connectors
between the Call Servers.
2 Complete procedures 22 through 27 for the second Call Server.
3 Each Call Server can be named: Call Server 1 and Call Server 0.
Note: Do not install LAN 1 and LAN 2 cables at this time.
Installing software on the CS 1000E
End of Procedure
Load program
Get the status of the CPUs
End of Procedure
End of Procedure
Communication Server 1000E
Page 141 of 488
Installation and Configuration