Nortel 1000E Installation And Configuration Manual page 379

Adding a Follower Signaling Server to an
IP telephony node
• Cancel. Closes the Transfer / Status pages without performing any
action, and displays the Node Summary web page.
6 If the Signaling Server configuration was changed on the Edit web page,
reboot the Signaling Server.
Follow Procedure 96 to add a Follower Signaling Server to the IP telephony
node in Element Manager.
Procedure 96
Adding a Follower Signaling Server to the IP telephony node in
Element Manager
Note: After software installation and reboot, the Follower Signaling
Server sends out BootP requests and waits for a response. Because the
Follower Signaling Server has not booted successfully before, it waits for
a non-existing BootP response. Do not wait for this response; proceed to
the next steps.
In Element Manager:
1 Click Edit on the Node Configuration web page (see Figure 132 on
page 373).
2 Click Add beside the Signaling Server row.
3 Enter the Follower Signaling Server data to an IP telephony node. Include
the ELAN MAC address (used to answer BootP requests).
4 Click Save and Transfer to save the changes and the Leader Signaling
Server then obtains a copy of the node files.
5 Click OK to save the node configuration to the CS 1000E and transfer the
configuration to all elements.
When the file transfer is complete, the Transfer/ Status web page
appears.
The Leader Signaling Server responds to the Follower Signaling Server's
BootP request.
The Follower Signaling Server initializes its network interfaces.
Communication Server 1000E
Configuring an IP telephony node
End of Procedure
Page 379 of 488
Installation and Configuration