Nortel 1000E Installation And Configuration Manual page 234

Page 234 of 488
Figure 85
Bulkhead connector on a Media Gateway
553-3041-210 Standard 4.00
Configuring a Small System Controller
3 Install the 100BaseT daughterboard (single port) in slot 2 of the SSC:
a. Locate the alignment pin on the SSC.
b. Insert the alignment pin into the appropriate hole on the 100BaseT
daughterboard (single port).
c. Secure the 100BaseT daughterboard (single port) using metal
screw-downs on the SSC.
d. Route the NTDU0606 Ethernet cable through the plastic guides on
the SSC.
4 Install the SSC in the Media Gateway.
5 Connect the NTDU0606 Ethernet cable to port 1 of the Media Gateway
bulkhead connector shown in Figure 85 on
6 Repeat Step 1 to Step 5 for each Media Gateway.
September 2007
page
End of Procedure
234.
Port 1