Nortel 1000E Installation And Configuration Manual page 468

Page 468 of 488
553-3041-210 Standard 4.00
Configuring MG 1000T survivability and alternate primary controller
The RIB command restores data from the MG 1000T Core's internal backup
flash drive to its (c:) drive and from the Survivable MG 1000T Expansions'
internal backup flash drive to the (c:) drive.
The RIB command is illustrated in Figure 158 on
Only one MG 1000T Expansion is shown for illustration purpose; however,
the synchronization is performed sequentially on all Survivable MG 1000T
Expansions.
DAT command
Use the DAT command to print the data issue and creation date of the
CS 1000E's primary and backup databases, as well as those of the Survivable
Media Gateways. The software release of the Survivable Media Gateways
must match that of the CS 1000E.
The DAT command is available in LD 43.
September 2007
page 471.