Page 186 of 488
Figure 63
Application configuration
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Please select the application configuration for this Signaling Server.
Please enter:
<CR> -> <a> - Co-resident (LTPS + VTRK + NRS).
<b> - Stand-alone (NRS only - no Call Server).
<q> - Quit.
Enter Choice>
553-3041-210
Standard 4.00
Installing and configuring the Signaling Server software
10 Configure the application configuration for this Signaling Server. See
Figure 63.
•
If the Set TPS, Virtual Trunk TPS, and optional Network Routing
Service (NRS) applications are to be enabled on this Signaling
Server, enter a at the prompt to configure this Signaling Server as a
co-resident Signaling Server.
•
If only the NRS is to be enabled on this Signaling Server:
— If this Signaling Server is to be associated with a Call Server,
enter a at the prompt to configure this Signaling Server as a
co-resident Signaling Server. After you finished installing the
Signaling Server software, you can disable the Set TPS and
Virtual Trunk TPS in Element Manager (refer to
Element Manager: System Administration (553-3001-332)).
— If this Signaling Server is not to be associated with a Call Server,
enter b at the prompt to set this Signaling Server as a
stand-alone Signaling Server.
September 2007