Enabling A Card Unit - Nortel 1000E Installation And Configuration Manual

Page 350 of 488

Enabling a card unit

553-3041-210 Standard 4.00
Installing and configuring a Voice Gateway Media Card
The output from this command is shown in the text box in the lower half
of the web page.
Follow Procedure 88 to enable a Voice Gateway Media Card unit using
Element Manager.
Procedure 88
Enabling a Voice Gateway Media Card unit using Element Manager
1 Select System > Maintenance from the navigator.
The Maintenance web page opens as shown in Figure 119 on
This page allows you to perform maintenance using overlays or using a
selected functionality. The default is overlay, as shown in Figure 119.
2 Select Select by Functionality.
The list in the web page changes to show a list of diagnostics you can use,
as shown in Figure 120 on
3 Select Network & Peripheral Equipment Diagnostics from the list in
Figure 120 on page
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 121 on page
4 Select the ENLU – Enable unit command from the Unit Commands
drop-down list.
5 Enter the card number and unit number in the corresponding Command
Parameter text box.
6 Click Submit to the right of the text box.
The output from this command is shown in the text box in the lower half
of the web page.
September 2007
End of Procedure
page 345.
345.
346.
End of Procedure
page 344.