Adding A Software Daughterboard And Remote Security Device - Nortel 1000E Installation And Configuration Manual

Page 226 of 488
Adding a software daughterboard and
remote security device
553-3041-210 Standard 4.00
Configuring a Small System Controller
Table 13
Small System Controller profile (Part 2 of 2)
Property
Connectors
Required
components
Accessories
Configuring an SSC can involve:
1 Procedure 56: "Installing an SSC NTM400 Software daughterboard and
NTDK57 (NT_REM) remote security device" on
2 Procedure 57: "Adding a 100BaseT daughterboard (dual port) to an SSC"
on page 227
3 Procedure 58: "Adding a 100BaseT daughterboard (single port) to an
SSC" on page 231.
A software daughterboard (NTM400) and a remote security device
(NTDK57) (NT_REM) must be installed on the SSC. Follow Procedure 56 to
install these required components.
September 2007
Description
• Port 1 – 100BaseT
• Port 2 – 100BaseT (optional)
• Port 3 – 100BaseT
• Port 4 – 100BaseT (optional)
• Remote Security Device (NTDK57DA)
• Software daughterboard (NTM400)
• Flash daughterboard (NTTK25BA)
• 100BaseT daughterboard (single port)
(NTDK99AA)
• 100BaseT daughterboard (dual port)
(NTDK83AA)
page 227.