Nortel 1000E Installation And Configuration Manual page 257

a. Set baud rate to 9600.
b. Set data bits to 8.
c. Set parity to none.
d. Set stop bit to 1.
e. Set flow control to "None".
f. Set Terminal Emulation to VT100.
g. Press <CR> until you receive a log-in prompt.
5 Log in to the Terminal Server. Enter:
ACCESS
6 Enter the user name. Enter:
ADMIN
7 Set privileged mode. Enter:
SET PRIV
8 Enter the password. Enter:
SYSTEM
Configuring the Terminal Server IP address
Procedure 63
Configure IP address for the Terminal Server
Note: The IP address can be configured or changed only from local
management port 20.
1 Configure the Terminal Server's IP address. At the In-Reach_Priv prompt.
Enter:
define server ip address [ip address]
2 Configure the Terminal Server's IP subnet mask. Enter:
define server ip subnet mask [ip address]
3 Configure the Terminal Server's IP primary gateway address. Enter:
Connecting a Terminal Server
End of Procedure
Communication Server 1000E
Page 257 of 488
Installation and Configuration