Entering Ip Phone Boot Parameters Using Partial Dhcp Parameters - Nortel 1000E Installation And Configuration Manual

Entering IP Phone boot parameters
using partial DHCP parameters
9 Enter the node number and the temporary or administrator IP Phone
Installer Password.
Note 1: An asterisk is displayed for each password digit entered; the
actual password is not displayed.
Note 2: If this screen times out, or if you do not successfully enter the
password in three attempts, the IP Phone continues its registration
process as if no entry had been made to this prompt. You can reboot the
telephone and try again if more tries are needed.
The IP Phone prompts:
TN: x.x
10 Enter the IP Phone's (virtual) TN.
The IP Phone displays the logo, the date and time, and the DN keys.
11 Check for dial tone and the correct DN above the display.
Follow Procedure 109 to enter IP Telephone boot parameters using partial
DHCP parameters.
Procedure 109

Entering IP Phone boot parameters using partial DHCP parameters

1 Power up the IP Phone.
Within four seconds, the Nortel logo appears.
2 When the Nortel logo appears on the display, you have one second to
press the four feature keys at the bottom of the display in sequence, from
left to right.
Note: If the Nortel logo times out, repeat step 1 and step 2.
3 For the following prompts:
a. Press the BKSpace (backspace) or Clear keys to change an entry.
b. Enter new values using the telephone's keypad.
Communication Server 1000E
Installing and configuring IP Phones
End of Procedure
Page 430 of 488
Installation and Configuration